[JonathanPT] Welcome to TOOBERS! (Jaiden Animations) [Ongoing] comic porn

The main components of the cocktail
A casing is a glass bottle filled with an inflammatory liquid. Alcohol bottles are commonly used for this case, but Spaniards in their civil war were known for using jam jars.

The bottle must be thick-walled and tough enough to stay intact while you’re handling it, though at the same time, it must be fragile enough to immediately break when it hits a target. So, it’s better to use beer or vodka bottles. On the other hand, wine or champagne bottles are usually too thick and sturdy and may not break.

Some guides recommend scoring a bottle with a knife or glass cutter, but in this case you should be very careful.

Fuel is the filling of a bottle. Any flammable liquids are suitable here, in particular alcohol, kerosene, gasoline, etc., but there are some nuances.

Alcohol will burn well, but it must be of a high proof. One can use vodka, but it’s better to use something stronger than it.

Gasoline burns strongly, but will not last long. Therefore, for example, the already mentioned Finns mixed it with roofing tar that served as a thickener. As a result, Molotov cocktails burned for a long time and stuck to targets.

Another option is to mix acetone and gasoline in a 1:1 ratio. But first you need to dissolve styrofoam somewhere in 100 grams of acetone, so you can achieve the consistency of a thick syrup. Use a lot of styrofoam as you may need it more than you think. Some types of styrofoam dissolve better in a mixture of gasoline and acetone.

A wick is used for ignition. One can use an ordinary rag or any other absorbent material cut into strips, as well as long storm matches, which are attached to a casting with a scotch tape. If you use a rag, do not take synthetic fabrics. How to make a cocktail
Fill the bottle with liquid somewhere around 3/4 (or less if there is a small amount of mixture).
Insert one half of the wick into the bottle so that it is impregnated with liquid.
Stuff another half of the wick……tightly into the neck of the bottle, so that liquid won’t dribble out.
Wrap the neck of the bottle with a rag and fix it with a piece of scotch tape so you don’t get burnt while throwing it.
The end of the wick sticking out of the bottle should not be long; 5 cm will be enough.
Do not wet it right away; it should be done shortly before throwing the cocktail.
Light the wick with a lighter and throw it at the target.
Done! You are masters of your craft!
Important tips
If you are not going to use a Molotov cocktail right away, close a casting with a cork or bottle cap. However, with each passing hour, the mixture inside becomes less effective as it begins to break down into layers as follows: lighter elements remain at the top, heavier ones settle at the bottom.

Do not light the wick right away; it should be done shortly before throwing the cocktail at the target.

The strip of rag does not carry the fire inside the bottle; the liquid ignites when the bottle is broken.

Use a Molotov cocktail only against targets that can actually break the glass.